Chrysler 300M Enthusiasts Club
  • how can i change the oil pressure switch???

  • Everything you need to know about changing the oil on your LH.
Membership Banner

Everything you need to know about changing the oil on your LH.

Moderator: Moderators

User avatar
 #261831  by jimgas
 
hello guys again!does anyone change the oil pressure switch?is easy to do it by myself???
User avatar
 #261836  by Bill Putney
 
Screws out of the block or a fitting (depending on if you have the oil cooler or not) like any pipe fitting, of course after you pull the connector off (simple latch involved). It's supposed to require a special sensor socket to keep from damaging it by distorting the case, but I was successful doing it just carefully using pliers.

Highly recommended to use OEM part and not aftermarket - been *lots* of reports that aftermarket ones are not properly calibrated and you'll get more oil light flickering.
User avatar
 #261862  by jimgas
 
im gonna buy an OEM cause i read that here again about the aftermarkets!!!so thank you so much!im gonna try change this weekend!!!
User avatar
 #261885  by Bill Putney
 
You're welcome, Dimitris.